CT24 MCU
User Manual
10
9M02-7608-A001-EN
Version 2.0
2.2
Intended Use
The product must only be used in good condition, by instructed personnel, and subject to compliance with all
applicable safety and accident prevention regulations. Use only for the intended purpose and according to the
instructions contained within this user manual.
2.3
Improper Use
Ensure compliance with equipment ratings and operate only as intended, in particular:
•
Only authorized and trained personnel should open the MCU cover and install/maintain
•
Ensure all supplies to the equipment are isolated before installation/maintenance
•
Check that power supply voltage/frequency data is correct
•
Do not misuse or exceed operating specifications
•
Ensure daily and periodic maintenance routines are observed
CAUTION
Damage to the device:
The unit is rated at IP65. For environments harsher than this, use an appropriate secondary
enclosure.
Neglecting the above can result in danger for life and limb and/or cause physical damage to the
product or the environment.
2.4
Safety Instructions for Assembly/Disassembly
Only trained and qualified persons may perform installation/maintenance work.
Note:
Ensure suitable transient protection devices are fitted to controlled electrical relays or valves. Ensure
correct wiring of the crane’s main contactor and the manual radio transfer switch.
•
Isolate the system from the electrical power in accordance with the applicable regulations.
•
Observe user-specific regulations.
•
Only use suitable tools.
•
Secure the installation area.
2.5
Operation of OCUs and MCUs with Identical System Address
To ensure safe operation, OCUs and MCUs are uniquely paired by way of a unique system address. This system
address will only be assigned once by the manufacturer.
CAUTION
Conflict of Addresses:
The user must ensure that the system address is used as designed and intended for a single
system.
The system address is marked on the master TransKey; the OCU and intended MCU address
must match.
In the event of a breach of this undertaking, the user is liable for any resulting damage/loss and
shall indemnify the manufacturer against all third-party liability claims.
!
!
