Cattron-Theimeg LRC-L1, User Manual

Page: 20 / 26

User Manual LRC-L1
20 Subject to change without notice. Version 1.0.0 - 11/2010
8 Troubleshooting
8.1 Transmitter Error Indication
Should an error occur, the Status-LED in the LED/Push-button panel of the transmitter unit will indicate the
cause of the error. This is done via a number of different blink sequences. The sequences and the relevant
corrective actions are listed below.
LED
Number of
flashes
Description Corrective Action
2
TransKey cannot be read
Plug in TransKey
3
Error detected in TransKey
configuration
Have the TransKey-configuration checked by
Cattron-Theimeg.
4
Low-voltage condition of the mains
supply detected
Change main board.
5
Switch-on sequence not carried out
correctly
Switch the transmitter off and on again, following
the correct switch-on sequence.
6
Fault during reading control elements
Replace control element or main board.
7
Internal communication error between
RF-module and main board
Replace RF-module or main board.
8
General system fault
Replace main board.
9
Low-voltage detection shortly after
switch-on
Change or charge battery.
10
Hardware fault
Replace main board.