Cattron-Theimeg LRC-L1, User Manual

Page: 5 / 26

User Manual LRC-L1
Version 1.0.0 - 11/2010 Subject to change without notice. 5
2 Safety Instructions
2.1 Used Symbols and Definitions for Warnings
!
Warning against hazardous situation
Warning against electrical voltage
!
Useful information
DANGER
Calls attention to a dangerous situation with high risk, severe injuries or death
possible.
WARNING Calls attention to a situation with medium risk, severe injuries possible.
CAUTION Calls attention to a situation with low risk, injuries or damage to the device possible.
NOTE Calls attention to important information.
2.2 General Information on Safety
•
Persons under the influence of drugs and/or alcohol and/or other medicine that impairs their reaction may
not assemble, disassemble, install, put into operation, repair or operate the product.
•
All conversions and modifications of an installation/system must conform to the relevant safety
requirements. Work on the electrical equipment must be performed only by qualified, authorized
personnel and in accordance with the relevant safety requirements.
•
In the event of malfunctioning and visible defects or irregularities, the product must be stopped, switched off
and the relevant master switches must be switched off.
WARNING
!
Observe the statutory regulations and directives applicable for the intended purpose, e.g.:
•
Accident prevention regulations
•
Safety rules and directives
•
Standards
•
Generally applicable statutory and other binding regulations for accident prevention and
environmental protection and general safety and health requirements.
•
The user must instruct his personnel accordingly.
•
The Operating Manual must be kept permanently accessible at the place of use of the product.
•
The personnel assigned to work on/with the product must have read and understood this Operating Manual
and the safety instructions.
•
The safety instructions must, if necessary, be supplemented by the user with instructions concerning the
work organisation, work sequences, used personnel, etc.
•
Only trained personnel may perform the work (maintenance and repair) with/on the product.
•
It is the user’s responsibility to ensure that the product is always operated in a perfect condition and that all
applicable safety requirements and regulations are being observed.
•
Product modifications may not be carried out without the consent of the manufacturer.
•
In any event, only original spare parts from the manufacturer must be used.
•
Periodical inspections and/or maintenance either required by law or prescribed in the user manual must be
carried out within the required intervals