4
Let's assemble
1
Mounting Front Leg
• Remove the leg plate from the
main unit. (This plate will not be
used for assembly.)
• Place the front leg (with casters)
under the main unit as shown in
figure and fasten screws securely
with the hexagon wrench making
sure nuts locate at the bottom of
the leg.
2
Mounting Rear Leg
• Place the rear leg (with level
adjuster) under the rear support
pipe as shown in figure and fasten
screws securely with the hexagon
wrench making sure nuts locate at
the bottom of the leg.
3
Mounting Seat and
Handlebar
• Mount the seat to the seat pipe
using the large screws and the
handlebar using the small ones.
hexagon wrench
large screws
small screws
spring washer
handlebar
front leg
(with casters)
nuts
flat washer
seat
spring washer
flat washer
4
2
1
3
7
8
6
4
2
5
nuts
rear support pipe
rear leg
(with level adjusters)
5
6
Mounting Pedals
• Attach the pedals to cranks using
the spanner wrench #15.
• Be sure to install the pedal (R) on
the right crank and (L) on the left
crank to avoid cross threading.
5
Connecting Inner Pipe
• Lift up the seat lock pin and pull out
the inner pipe by a proper length
for easier connection.
R e m o v e
the 3 screws from the end of the
inner pipe.
• Insert the inner pipe into the joint
fitting of the main unit and fasten it
securely with the 3 screws.
4
Assembling Rear
Frame
• Loosen and remove the seat height
lock knob.
• Insert the rear support pipe into the
socket of seat pipe. Select any
height and tighten the knob.
spanner wrench #15
PULL
SLIDE
lock pin
screws
inner pipe
joint fitting
1
6
5
3
(L)
FRONT
(R)
Caution: If the pedals are not
attached firmly enough to the
crank, they can an irritating
noise. Be sure to attach them
firmly.
seat height lock knob
rear support pipe
R
EC-3600
