Cateye EC-T220, Instruction Manual

Page: 9 / 44

9
4
Attach the control unit base to the handle masts.
• Position the control unit cross to the handle masts, and then pre-
pare to pass the cords through the handle mast inside.
Caution: Be careful that the control unit does not fall down.
• Remove the wire (lower side) which is wrapped around the
handle mast.
• Through the lower opening, pull the wire which comes from
the handle mast inside, and draw the 3 cords from the inside.
Caution: Do not pull the wire forcefully. Pull the cords gradu-
ally while the cords are sending from the upper part of
the handle mast.
• Fit the control unit onto the handle masts and fix it using the 4
bolt As.
Caution: Be sure that the cords are not pinched when installing
the control unit base onto the handle masts.
Control unit
Cords
Bolt A
Handle mast
1
2
3
5
Attach the connectors on the 3 cord ends to the
circuit board inside the main body.
• Connector (white) :
1
Connector (big) :
3
Connector (small) :
2
Caution: The shape of the connectors on each of the 3 cords is
different. Be sure to connect each of them to the cor-
rect place.
Circuit board inside main body
Cord
EC
-T
22
0
6
Attach the motor cover.
• Remove the 4 screws, put the motor cover in position, and replace
the 4 screws to fix it in place.
Screw
Motor cover
Circuit board
Cords