Cateye CC-TR100 Instruction Manual Download Page 21

Page: 21 / 28

CC-TR100

MODE-

Haert rate sensor ID menu screen

Data storage menu screen

Heart rate zone menu screen

MODE-

Data file menu screen

For the basic information on how to use the
menu screen, refer to page 28.

MODE-

S/S/E

Data file

You can check and manage data files recorded by the TR100.

Display 1 indicates the remaining amount of storage (%). Display 3 indicates the total number
of laps used in that data file. Display 4 indicates the data file number.

NOTE:

• To view and use the contents of the stored data files, the optional download kit (and

or power unit) is required.

• When there are no date files recorded (“F-0” on Display 4), this screen cannot be

operated.

Remaining memory

D a t a f i l e
number

Number of laps used

Data file menu screen

• Checking data files

You can check data files by pressing the START/STOP/ENTER button.

The screen displays the data file number, recording interval, memory consumption, number
of laps, date and time when the file was recorded, and exercise duration.

To switch the data file number, press MODE-1 or MODE-2.

NOTE:

• Up to 99 data files can be stored until the remaining memory is at 0%.

• When the remaining memory reaches 0% while data storge is in progress, your

data file will end at that point. Measurement continues, however, data is no longer
stored in a data file. New data files will not be created.

• When data is transferred to a personal computer using the optional download kit,

“move data” is performed and the data files are deleted from the TR100.

(“Move data” can be changed to “Copy data”. For details, see the instruction manual
for the download kit.)

Alternating data display

Switch file

End

Memory consumption

Recording interval

Number of
laps used
in file

Date of ride

Ride time

Ride start time

Data file check screen

File number

For the basic information on how to use the
menu screen, refer to page 28.

S/S/E

Heart rate sensor ID

This function allows the ID signal transmitted by the heart rate sensor to be received and
checked.

Before checking HR sensor ID, mount the main unit to the HR receiver.

NOTE:

Be sure to attach the main unit to the HR receiver. Signals from the heart rate sensor
cannot be received by the main unit alone.

Within 5 minutes of pressing the START/STOP/ENTER button, place the HR sensor approxi-
mately 20-80 cm from the main unit and press the reset button on the HR sensor for five
seconds to transmit the ID signal.

When the main unit receives the ID signal, the ID check has been completed.

You can view the ID number but cannot reset it while the bicycle is in motion.

NOTE:

• Failure to receive the ID signal within five minutes or the pressing of the START/

STOP/ENTER button cancels the heart rate sensor ID set mode, leaving the ID as it
was.

• The minimum transmission of the heart rate sensor is 20 cm. The signal will be too

strong to perform the heart rate sensor ID check if the chest strap is within 20 cm of
the main unit.

• When two or more users with this unit ride side by side with the same ID, interfer-

ence can occur and correct measurement may be impeded. In such a case, change
the ID using the following the steps below:

After ID checking, the ID viewing screen reappears automatically.

Heart rate sensor reset button

ID standby screen