Catalyst 180-R, Assembly Manual, Page: 67 / 74

Parts Required:
1 X HD Camera Mount (Black 3D Printed TPU)
2 X Button Head Screw (M3 x 10mm long x Steel)
2 X Socket Head Screw (M3 x 10mm long x
blue 7075 aluminum )
4 X Washer (M3 x aluminum or steel)
1 X Velcro Strap – Catalyst Machineworks
Assembly Process:
Use the two existing socket head screws located at the front of the FPV camera cage, and the two steel button head
screws (which are included with your camera mount) to fasten the mount down. Use one washer per screw. Install your
camera into the mount then run the Velcro Strap through the slot in the camera cage and around the camera. Make
sure the strap is nice and tight. At 70 MPH your camera might tend to move a bit in flight!