Catalyst 180-R, Assembly Manual, Page: 54 / 74

STEP 14
Parts Required:
1 X Assembled HS1177 FPV Camera (from previous step)
2 X FPV Camera Cage, Side Plate (1.5mm CF)
1 X FPV Camera Cage Top Plate (3mm CF)
4 X Socket Head Screw (M3 x 10mm long x
blue 7075 aluminum )
2 X FPV Camera Mount Adjustment Screw (Phillips head #4 x 3/8” long x stainless steel)
Assembly Process:
Insert the signal/power wire into the FPV camera. Position the holes in the Camera Cage Side Plates onto the nubs on
the sides of the camera housing. While pressing the assembly together with your hands, feed the Camera Cage Side
Plates down into the slots in the Main Frame Plate. Press the Camera Cage Top Plate in place then install the 4 M3
socket head screws as shown. Set your FPV camera at the desired angle (0° - 45°) then install the 2 Camera Mount
Adjustment Screws. You should not use much torque on these screws! Only enough to hold the camera in place.