Cata CME6106, Operating And Maintenance Instructions Manual

Page: 59 / 112

agent or similarly qualified persons in order to avoid a danger or injury.
• The appliance is not intended to be operated by means of an external timer or separated re-
mote control system.
• The appliance is for domestic use only and only for cooking food. Do not use this appliance as
a source of heat.
• The manufacturer declines all liability for personal or material damage as a result of misuse or
incorrect installation of this appliance.
• Danger of burns! During use the appliance becomes hot. Care should be taken to avoid tou-
ching heating elements inside the oven.
• Do not lean on the door or place any objects on the door of the appliance. This can damage
the door hinges.
• The oven must be installed in accordance with installation instructions and all dimensions
must be followed.
• Before connecting the appliance to the power supply, check that the power supply voltage and
current rating corresponds with the power supply details shown on the appliance rating label.
• Never use a damaged appliance! Disconnect the appliance from the electrical outlet and con-
tact your retailer if it is damaged.
• Danger of electric shock! Do not attempt to repair the appliance yourself. In case of malfunc-
tion, repairs are to be conducted by qualified personnel only.
• To avoid damaging the cord, do not squeeze, bend or chafe it on sharp edges. Keep it away
from hot surfaces and open flames.
• Lay out the cord in such a way that no unintentional pulling or tripping over it is possible. Keep
the appliance and its cord out of reach of children.Do not operate the appliance with wet hands
or while standing on a wet floor.Always turn the appliance off before disconnecting it from the
power supply.
• Disconnect the oven from the power supply when not in use and before cleaning.
• Warning: This appliance is supplied with a three core supply cord and must be connected
direct to the mains electricity supply via a omni-polar or double pole switch having a 3mm
minimum contact gap on each connector.
• The fused spur should be installed in an easily reachable place so that in case of emergency
the appliance can be disconnected from power immediately.
• The fixed wiring must be protected against heat surfaces.
• Do not hang any objects on the handle of the oven door.
• Caution: Do not cover the bottom of the oven with aluminium foil or other objects. There is a
risk of fire and damage to the enamel in the oven!
• Do not allow aluminium foil, plastic, paper or fabric contact with heating elements. Never leave
the appliance unattended during use, especially when cooking with flammable substances
(e.g. hot oil, fat, etc.).
• Do not store or never use harsh chemicals, sprays, flammable or non-food in or near the oven.