CASO DESIGN 01884, Original Operating Manual

Page: 37 / 139

37
Please note
► The lifetime of the waterfilter lasts about 4-6 weeks of normal use (filtering of
approximately 160 l water in total).
► Despite soaking the filter beforehand, a small residue of black carbon particles may leak
out during use. This is normal and harmless.
► Make sure that the bottom of the filter is always in contact with water and never allow it to
dry out. If the filter does dry out, then re-soak it for 10 minutes.
► Change the water in the tank every 48 hours at the latest.
► Store the water tank and filter in a cool place and keep them out of direct sunlight.
14.1.1 Preparation of the device
1. Place the device on a hard surface.
2. Fill the tank with approx. 1 litre of water.
3. Place a vessel which can hold approx. 700 ml water under the spout.
4. Start the device with 000 temperature setting until ca. 300 ml water is dispensed.
5. Set the device to 100°C and dispense 400 ml water.
6. The device can now be equipped with waterfilter and filled with fresh water.
7. The device is ready for use.
14.1.2 Set the water hardness
Press and hold -button , the display shows „001“ or „002“ as Volume. „001“ stands for
soft water. This means that „Descale“ will light up in the display after 60 litres of water were
dispensed. „002“ stands for hard water. This means that “Descale” will light up in the display
after 25 litres of water were dispensed. With the -button you can change between „001“
and „002“ confirm with Start/Stop.
14.2 Use
1. Fill the watertank with water. Pay attention to the mark which shows the maximum water
amount.
2. Insert the water tank into the device and place its lid on top of it.
3. Depending on how much water you want and the container size, place the drip tray or drip
tray with cup platform in front of the device. The drip tray can be hooked onto the device.
4. Place your cup or container on the drip tray. Make sure that the cup is located under the
water spout.
5. Plug the power socket into mains power.
6. First press -button about 3-5 seconds for unlocking the device.
7. Press -button to choose your desired temperature and press -button to set the
water volume.