CASO DESIGN 01884, Original Operating Manual

Page: 33 / 139

33
12.2 Delivery scope and transport inspection
As a rule, the device is delivered with the following components:
● CASO HW 1660 ● Waterfilter
● Filter holder ● Cup platform
● Operation Manual
Please note
► Examine the shipment for its completeness and for any visible damages.
► Immediately notify the carrier, the insurance and the supplier about any incomplete
shipment or damages as a result of inadequate packaging or due to transportation.
12.3 Unpacking
To unpack the device, proceed as follows: Remove the device out of the carton and remove
the packaging material. Remove the protective fi lm from the unit.
12.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled. Returning the packaging back to the material loop saves
raw materials and reduces the quantities of accumulated waste.
Take any packaging materials that are no longer required to “Green Dot” recycling collection
points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of a
guarantee claim.
12.5 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:

The device must be set up on a firm, flat, horizontal surface with sufficient load-bearing
capacity for the device.

Place the device only on a waterresistent surface.

Do not use the device outdoors.

Do not operate the product near hot gas or hot stove.

Choose the setup location in such a way that children cannot reach the device.

The device is not intended to be installed in a wall or a built-in cupboard.

Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.

The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.

The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.