Page 7
Adding Adhesive
Maxit adhesive comes in pellets which normally stick together in the bag. Either cut the
required amount with a knife or alternatively, refrigerate the product for approximately 2
hours. It is then easy to tear off the adhesive in the pieces you require.
When the adhesive level drops to the ‘add level’ add more adhesive. It is important to
maintain the adhesive level at, or above, the ‘full’ level. If not, you will not achieve the
correct coating and it will take longer to warm up in the morning.
Add adhesive Bag dissolves too!
Pull down the front cover. Place approximately half of the adhesive pellets in the front of the
tray. You do not need to wait for the pellets to melt before using the Maxit. The bag is made
from a special material and is dissolvable in the hot adhesive.
Cleaning
Remove side screws Slide out top half of covers
Swivel top roller back
WD-40, although a lubricant, is excellent for cleaning adhesive from the outside casing. If
adhesive appears on the top roller, remove the screws from the sides of the Maxit, slide off
the top halves of the covers and swivel back the top roller. Then use WD-40 to clean it.
