50
4.
To stop template projection, change to another input source or turn off the
projector.
If you turn off the projector while a template is being projected, the same template will be
projected again when you turn power back on.
Note
Note that an image input signal being input to the projector cannot be projected while a
template is being projected.
Auto Projection Off (page 43) and Auto Power Off (page 60) are both disabled while a template
is being projected.
With an XJ-UT352W, XJ-F11X, and XJ-F101W model, the following settings cannot be
adjusted while a template is being projected: “Brightness” (page 56), “Contrast” (page 56).
To change the template type (XJ-UT352W, XJ-F11X, XJ-F101W)
1.
While a template is being projected, press the [FUNC] key and then the [ENTER]
key.
This displays the “Template Type” menu.
2.
Use the [
] and [
] keys to select the template you want to project, and then
press the [ENTER] key.
To change the template type (Network Models)
1.
While a template is being projected, press the [FUNC] key and then the [ENTER]
key.
This displays the template selection screen.
2.
Use the cursor keys to move the focus to the template you want to project.
To project a template that is located in a folder that is different from the currently displayed
folder, perform the steps below.
(1) While the focus is located at any template on the far left, press the [
] key.
This moves the focus to the folder selection area.
(2) Use the [
] and [
] keys to move the focus to the folder that contains the template you
want to project.
(3) Press the [
] key.
This moves the focus back to the template selection area.
(4) Use the cursor keys to move the focus to the template you want to project.
3.
Press the [ENTER] key.
Note
Under network model initial default settings, only the top folder contains templates. All of the
other folders are empty. For information about the procedure to add a template, refer to the
separate “Network Function Guide”.
