Case CX135SR, Operator'S Manual

Page: 50 / 186

CHAPTER 3 - INSTRUMENTS AND CONTROLS
3-22
Issued 8-04 Bur 6-34551NA
6. Console and seat adjustment
Pull the lever (6) upwards, and slide the seat and
control arm assembly to the desired position, then
release the lever.
CT02C081 Figure 53
7 - Armrest angle adjustment
Lift the armrests, turn the knob (7) to get the desired
angle then lower the armrest.
CT02C082
Figure 54
8 - Headrest adjustment
The headrest (8) can be adjusted upwards and
downwards and backwards and forwards.
NOTE: To make the headrest return to its initial
position (to the rear), tilt it completely forwards and
then release it.
CT02C083 Figure 55
7. Safety belt
Sit comfortably on the seat, pull the seat belt out then
engage it in the kink system (9).
If the section of belt pulled out is not long enough,
release it, so it rolls up and then pull it out again.
To fasten the seat belt, insert the buckle in the slide
closing of the opposite belt. To unfasten the seat belt,
lift the slide closing of the opposite belt.
To release the seat belt, press down on the releasing
lever (9).
IMPORTANT: Inspect the seat belt. Make sure that it
is not damaged, that the mounting screws are
correctly tightened and replace any defective parts.
The seat belt must be kept clean. Use only soap and
water to clean the belt, do not use bleach or dies.
CT02C084
Figure 56
6
7
WARNING: Always fasten your safety belt
before starting the engine. The safety belt will
protect you effectively if you fasten it correctly
and wear it at all times. The safety belt should
not be too loose. It should not be twisted or
caught in the seat.
8
9