Case IH MAXXUM 110 EP, Service Manual

Page: 26 / 81

INTRODUCTION
PROTECTING THE ELECTRONIC/ ELECTRICAL SYSTEMS DURING CHARGING OR WELD-
ING
WARNING
Battery acid causes burns. Batteries contain sulfuric acid.
Avoid contact with skin, eyes or clothing. Antidote (external): Flush with water. Antidote (eyes): flush
with water for 15 minutes and seek medical attention immediately. Antidote (internal): Drink large
quantities of water or milk. Do not induce vomiting. Seek medical attention immediately.
Failure to comply could result in death or serious injury.
W0111A
To avoid damage to the electronic/electrical systems, always observe the following:
1. Never make or break any of the charging circuit connections, including the battery connections, when the engine
is running.
2. Never short any of the charging components to ground.
3. Always disconnect the ground cable from the battery before arc welding on the unit.
• Position the welder ground clamp as close to the welding area as possible.
• If welding in close proximity to a computer module, then the module should be removed from the unit.
• Never allow welding cables to lay on, near or across any electrical wiring or electronic component while welding
is in progress.
4. Always disconnect the negative cable from the battery when charging the battery in the unit with a battery charger.
NOTICE: If welding must be performed on the unit, the battery ground cable must be disconnected from the battery.
The electronic monitoring system and charging system will be damaged if this is not done.
SPARE PARTS
Only use "CNH Original Parts" or " CASE IH Parts".
Only genuine spare parts guarantee the same quality, duration and safety as original parts, as they are the same
parts that are assembled during standard production. Only "CNH Original Parts" or " CASE IH Parts" can offer this
guarantee. When ordering spare parts, always provide the following information:
• Machine model (commercial name) and serial number
• part number of the ordered part, which can be found in the "Spare Parts Catalogue", used for order processing
TOOLS
The tools that CASE IH suggests and illustrate in this manual have been:
• specifically researched and designed for use with CASE IH machines
• essential for reliable repair operations
• accurately built and rigorously tested so as to offer efficient and long-lasting operation
By using these tools, Repair Personnel will benefit from:
• operating in optimal technical conditions
• obtaining the best results
• saving time and effort
• working in safe conditions
NOTE: Wear limit values indicated for certain parts should be considered to be recommended, but not binding. The
terms "front", "rear", "right-hand" and "left-hand" (when referred to different parts) are determined from the rear, facing
in the direction of travel of the machine during operation.
47665854 27/03/2014
17