Case IH Farmall 105U Efficient Power, Service Manual

Page: 16 / 61

INTRODUCTION
Basic instructions for arc-welding on tractors with electronic lift
ATTENTION: Observe the following precautions when carrying out arc welding on a tractor fitted with an electronic
lift.
- Where possible, remove the part or implement that requires arc welding from the tractor.
- Disconnect both battery leads. Isolate the cable ends to avoid contact with each other and the tractor.
- Position the welder ground clamp as near as possible to the area where welding is to take place.
- Remove the electronic control units located on the tractor if welding is to be carried out near these control units.
- Never allow welding cables to lay on, near or across any electrical wiring or electronic component while welding is
in progress.
84568025 22/03/2013
9