19
3-3. RECORD
Set the values for recording video. Navigate through menu items by pressing the UP/DOWN
buttons. User can change the value of the menu item by pressing the LEFT/RIGHT buttons.
Menu items in RECORD mode setup
RESOLUTION:
Set resolution. (360*240, 720*240 or 720*480)
CHANNEL:
Select the channel for applying the following settings.
FRAME RATE:
Set the frame rate. The sum of the frame rate values from each channel cannot
exceed maximum frame rates for a particular recording resolution. Typical values of the maximum
frame rate for NTSC video are 120/100 fps for 360*240(NTSC)/360*288(PAL) and 30/25fps for
720*480(NTSC)/720*576(PAL).
QUALITY:
Select the recording quality for the specified channel.
[Network, Standard, High, Superior and Ultra]
RECORDING:
Assign the recording mode for each channel.
[Continuous, Motion, Sensor, Schedule, and Disable]
MOTION ZONE:
Select Full Zone or Partial Zone for motion sensing.
Press SEL button to setup motion sensing area.
MOTION SENSITIVITY:
Set the motion sensitivity. Control the motion sensitivity from 1 to 9.
SENSOR RECORDING:
Select sensors to record for the specified channel.
You can set the sensor type from DEVICE setup menu. (N/O or N/C)
PRE RECORD:
Enable/disable pre-event recording. Pre-event recording time is 5 seconds
and only intra-frames are recorded for pre-event recording.
POST EVENT RECORD:
Set post event recording time duration. (2 ~ 30 seconds)
AUDIO:
Enable/disable audio for the specified channel.
SCHEDULE:
Set recording schedule. Press SEL button to setup schedule.
Figure 3.3.1 RECORD mode setup screen
