Cascade E Series, Installation Instructions Manual

Page: 3 / 14

1
GA0080.ill
GA0082.ill
RUCK REQUIREMENTS
Clamp
Sideshift
Right
Tilt
Forward
Hoist Up
Auxiliary Valve Functions
Check for compliance with ANSI standards:
WARNING: Rated capacity of the truck/
attachment combination is a responsibility of the
original truck manufacturer and may be less
than that shown on the attachment nameplate.
Consult the truck nameplate.
Carriage
Clean carriage bars and inspect for
damaged notches
T
Tilt
Back
Hoist Down
Release
Sideshift
Left
GA0028.ill
A
Carriage Mount Dimension (A)
ITA (ISO)
Minimum Maximum
Class II 14.96 in. (380.0 mm) 15.00 in. (381.0 mm)
Class III 18.68 in. (474.5 mm) 18.74 in. (476.0 mm)
Truck Relief Setting
2300 psi (160 bar) Recommended
2600 psi (180 bar) Maximum
Truck Flow Volume
➀
Min.
➁
Recommended Max.
➂
20E, 30E, 5 GPM 7.5 GPM 10 GPM
40E, 45E (19 L/min.) (28 L/min.) (38 L/min.)
➀
Cascade E-Series Carton Clamps are compatible with SAE 10W
petroleum base hydraulic fluid meeting Mil. Spec. MIL-0-5606 or
MIL-0-2104B. Use of synthetic or aqueous base hydraulic fluid
is not recommended. If fire resistant hydraulic fluid is required,
special seals must be used. Contact Cascade.
➁
Flow less than recommended will result in reduced system
performance.
➂
Flow greater than maximum can result in excessive heating,
reduced system performance and short hydraulic system life.