8
SCREW
6-32 X 1”
(2)
SCREW
6-32 X
3
/
8
”
(2)
WOOD
SCREW
1” (2)
DRYWALL
ANCHOR
6-32 (2)
12V BATTERY
W-72
CONTROL
W-72
CONTROL
HOLDER
VerSa•ToUch 2
♦
INSTALLATION
VerSa•ToUch 2
♦
CONTROL BRACKET INSTALLATION
Standard Light Switch
Step A.
Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step B.
Orient the control bracket as shown and line up the
two inner mounting holes with those on the switch.
Step C.
Install and tighten screws by
hand
only.
INNER
mOUNTINg
HOLES
CONTROL
BRACKET
STANDARD
TOggLE
SWITCH
SWITCH
COVER
pLATE
Rocker Light Switch
Step A.
Break off the two tabs by pushing outward.
Step B.
Remove the two screws holding the switch cover
plate. Do not remove the cover plate.
Step C.
Orient the control bracket as shown and line up the
two inner mounting holes with those on the switch.
Step D.
Install and tighten screws by
hand
only.
OUTER
mOUNTINg
HOLES
CONTROL
BRACKET
ROCKER
TYpE
LIgHT
SWITCH
SWITCH
COVER
pLATE
Wall Installation
Step A.
Locate a 2x4
wall stud in a convenient
location.
Step B.
Orient the control
bracket as shown over the
2x4 stud.
Step C.
Use the 1” wood
screws in either the inner
or outer mounting holes.
Install and tighten screws
by
hand
only.
DECOR OVALHEAD SCREW
6-32 X 1”
ANCHOR
pANHEAD
SCREW
WOOD
SCREW 1”
DRYWALL ANCHOR
note:
The wall anchors and 6-32 x 1” screws may be used
in situations where mounting to a stud is not possible.
Use the inner mounting holes. After securing the anchor,
discard the anchor’s pointed screws and use the 6-32
decor ovalhead screws supplied.
CAUTION! Do not use with wall dimmer.
changes or modifications not expressly
approved in writing by casablanca fan co.
may void the user’s authority to operate
this equipment.
This device complies with RSS-210 of Industry Canada. Operation is subject to
the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
Warning: To reduce the risk of electrical shock, this fan must be installed with an
isolating wall control/switch.
SAFETY FIRST
®
