9
L
a
F
Leur
™
LIGHT FIXTURE INSTALLATION
Step 9a.
Connect the two-pin connector from the light socket
center stem assembly to the two-pin receptor hanging from
the motor housing.
Step 9b.
Thread each of the two provided screws through
a screwhole in the light socket center stem assembly and
a screwhole in the motor housing and tighten using the
provided screwdriver.
Step 9c.
Insert a provided 60-watt G-16.5 lightbulb into each
light socket and twist until snug.
Step 9d.
Carefully lift the glass up to the light socket center
stem assembly and insert the threaded post of the assembly
into the hole in the glass. While continuing to hold the glass
up with one hand, screw the light fixture finial onto the
threaded post with the other hand.
WARNINg! Do not allow the light socket center
stem assembly to hang by the wire.The fixture could
fall and cause injury or damage the fan.
Perma•Lock™ Hardware
(not to scale)
Glass Shade
Light Socket Center
Stem Assembly
Light Fixture
Finial
OPTIONAL NO-LIGHT CAP INSTALLATION
If you choose not to install the light fixture, you must install
the no-light cap finial.
Step 9a.
Tuck the wires inside the no-light cap finial, then
twist the finial onto the motor housing until tight.
No-Light
Cap Finial
60-watt g16.5 bulb
(Candelabra-base)
