8
Canopy Washer
Canopy Screw
Canopy Hatch
Step 8a.
Tuck the wires into the canopy
with the wire nuts pointed upwards, so
that the WHITE and BLACK wires are
on opposite sides of the canopy and all
wires are clear of the canopy opening.
Step 8b.
Install canopy hatch with the last
canopy screw and lock washer using the
provided screwdriver. To do this, tilt the
fan body away from the hatch opening.
Tighten the screws firmly.
Step 8c.
Straighten the fan, then check
to ensure that there is no movement
between the canopy and the ceiling or
the Perma•Lock downrod and the ball
assembly.
CANOPY HATCH INSTALLATION
Step 7
. Attach the fan wires to the ceiling fixture outlet box
wiring by placing the bare ends of the wires side by side and
then securing with a wire nut. Test that the connection is
secure by pulling on the wire nut. Connect in this order:
• GREEN leads from mounting plate and downrod assembly
of fan to GROUND conductor of power source. Secure
with wire nut.
• WHITE wire from fan to white NEUTRAL wire in ceiling
fixture outlet box. Secure with wire nut.
• BLACK power wire from fan to BLACK power wire in
ceiling outlet box. Secure with wire nut
After making the wire connections, the wires should be spread
apart with the grounded conductor and the equipment-
grounding conductor on one side of the outlet box and the
ungrounded conductor on the other side of the outlet box.
NOTE: If the color of your ceiling wires differs from that
described, consult an electrician.
2 White Wires
2 Black Wires
Wire Nut
3 Green Wires
Tilt the fan to install last
canopy screw
Step 6a.
To hang the fan body in the canopy, hold the fan body
firmly and insert the ball into the canopy opening. Check that
no wires were pinched. Rotate the fan body until the slot in
the ball fits into the pin opposite the canopy opening.
Step 6b.
Trim excess motor wires, leaving at least 6 inches
above the downrod. Strip
1
/
2
-inch insulation from the end of
each wire using a wire stripper (available at your local hardware
store). The splices after being made should be turned upward
and pushed carefully into the outlet box.
Pin
Slot
Ball
HANGING THE FAN
CANOPY ELECTRICAL CONNECTIONS
