6
Step 4a
. In order to install the blades, remove the five shipping
blocks attached to the rotating motor plate using the provided
screwdriver. Save these screws for use in Step 4d.
Step 4b.
Attach a two-piece blade medallion to each blade
by sandwiching the narrower end of a blade between a
medallion front and medallion back, threading the medallion
screws through the matching holes in the three pieces, and
tightening the medallion screws securely using the provided
screwdriver. (Note: The medallion front should be attached
to the side of the blade you want facing downward from the
ceiling.) Repeat for each blade assembly.
Step 4c.
Attach a blade iron to each blade by threading two
B screws through the blade iron and blade badge screw holes,
then tightening the screws securely using the provided Allen
wrench.
Step 4d.
Attach each blade/blade iron assembly to the upper
edge of the motor by threading two C screws through the
matching holes in the blade iron and the motor, then tightening
the screws securely using the provided screwdriver.
REMINDER: Five of the 10 C screws needed for this step
were removed from the shipping blocks in Step 4a.
BLADE INSTALLATION
Reversible Blade (total of 5)
BLADE HARDWARE
(not to scale)
Screw A for attaching
Medallion Front and Back
to Blade (4 per blade)
Screw B for attaching
Medallion to Blade
Iron (2 per blade)
Blade Iron
Medallion Front Medallion Back
Screw C for attaching
Blade Iron to Motor
Housing (2 per blade iron)
Screw A
Screw B
Screw C
Allen Wrench
Phillips Screwdriver
Shipping Block
