3
C
AMPANA
™
PREPARATION INSTRUCTIONS
Unpacking: Before assembling and installing your ceiling fan, remove all parts from the shipping cartons and check them
against the parts listed here. Before discarding packaging material, be certain that all parts have been removed.
CEILING HARDWARE
CROSSBAR
MOUNTING
BRACKET
WIRE NUT (4)
FAN PREPARATION
GETTING STARTED
Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either circuit breaker
or fuse box), lower the old fixture and disconnect the wiring.
Check the ceiling fixture outlet box to be sure that it is
marked ‘
Approved for ceiling fan mounting
’. If it is not, a new
box must be installed.
Warning: To reduce the risk of fire, electrical shock,
or personal injury, mount to outlet box marked
acceptable for ceiling fan support using the mount-
ing hardware provided with the outlet box.
ADDITIONAL HARDWARE
2
1
/
4
″
x 8-32 ROUNDED
HEAD SCREW (2)
FLAT WASHER (2)
1
″
x 8-32 ROUNDED
HEAD SCREW (2)
PERMA•LOCK™ HARDWARE
DOWNROD & BALL
ASSEMBLY
ALLEN SET SCREW
1
⁄
4
-20 x
1
⁄
4
"
(PRE-INSTALLED)
3mm
ALLEN WRENCH
Prepare for fan installation as follows:
Step A.
Route the wires from the motor through the
Perma•Lock™ downrod and ball assembly.
Step B.
Using the provided allen wrench, loosen the set screw
several turns to allow installation of the downrod. Thread
the downrod into the motor coupling until it stops turning,
this will take at least four and a half full turns.
Step C.
Securely tighten the set screw with the provided allen
wrench to ensure safe operation of your fan.
Tip:
The downrod has a tapered thread
that is designed to lock completely when
correctly installed.
CAUTION: Failure to fully lock in the down-
rod before securely tightening the allen set
screw may cause the fan to separate from
the downrod during normal operation!
IMPORTANT SAFETY INFORMATION!
BEFORE STARTING THE INSTALLATION OF YOUR CEILING FAN, INSTALL THE
THREADED DOWNROD INTO THE MOTOR COUPLING AND LOCK THE ASSEMBLY
MOTOR
COUPLING
TAPERED
THREAD
MOTOR
WIRES
GROUND
WIRE
ALLEN
SET SCREW
DOWNROD
& BALL
ASSEMBLY
