GPS Installation
Connect the GPS antenna cable (indoor use only) to the GPS port of the eFemto.
Note:
The GPS antenna must stay connected to the eFemto at all times for
operation. The initial GPS fix can take up to 60 minutes.
Ethernet and Power Connections
Attach the supplied Ethernet cable from your router or modem LAN port to the
eFemto WAN/PoE port for network connectivity.
Plug in the Power Supply and insert the power cable into the eFemto Power port.
Automatic startup and hardware initialization will begin.
POWER ON
At startup, the eFemto will conduct self configuration. This will take between
30 - 60 minutes the first time the eFemto turns on.
Copyright 2022 Casa Systems. All rights reserved.
Optional Accessories Available
Power over Ethernet (POE) Device
A full list of optional accessories can be viewed and ordered from
www.verizonwireless.com.
Automated Startup
The following Status LED sequence will occur. Upon successful setup, the LED will
blink green.
Note
: If the LED fails to turn green after one hour or is blinking a series of red
pulses, consult the troubleshooting section (below).
Troubleshooting
No GPS Signal
The Sync LED off and Alarm LED fix red indicates no GPS signal. Check the About
eFemto page in the Advanced Settings web interface, on the tabs for “Status and
Alerts” or “GPS” to see the status of the GPS constellation.
Is my wireless device connected to the eFemto?
Using the Advanced Settings web interface, sign in and the Connected Devices
panel for indication of connected users.
Cannot reach eFemto GUI or locked out of device.
Press the RESET button for 10 seconds to reset the system to factory default
settings.
4G/5G Network Extender 4
for Enterprise
Installation Reference Guide
Doc-3220 Rev 4.0
