9
INSTALLATION
3. Attach the head guide to the support then
fasten with screws.
4. Attach the head to the head guide then
fasten with stop bolt.
5. Insert the power line and wire of load cell into
the connector on the rear head.
1. Insert the power line into the support then
fasten with a bushing and bolts.
2. Arrange the wire then insert the support cover
to the support.
8
C
ON
OFF
PCS
U.W.
TARE
ZERO
Clear key used to clear recorded unit weight or recorded quantity.
When you know the number of the samples, you can get the unit
weight by pressing this key.
When you know the unit weight, you can get the number of
the samples by pressing this key.
Used to set the ZERO point.
Used to clear TARE entries and to enter TARE weight.
Used to enter the limited quantity.
Turns the display on or off.
Set all displays to Zero.
KEYS
FUNCTIONS
AC power cord
terminal
Fuse holder
Load cell connecter terminal
Span hole
Power
line
Head
guide
Head
Stop bolt
Support
cover
Support
ON / OFF switch
REAR PANEL
Fuse Holder: There is a fuse to protect circuit.
If the scale does not operate while power is on, check the fuse and replace it
by a new one.
AC power cord terminal: Insert AC power cord completely.
Load Cell Connector terminal: It is a connector terminal to link with Load Cell
cable that sensing weight. Insert connector and tighten the bolt by turning to
the right.
