CARVIN
®
SILVER SERIES ABOVE-GROUND POOL | USER MANUAL
14
Skimmer
Water return outlet
2’’
STEP 9
Complete the filling of the pool until the water reaches 1.5 to 2” below the top of
the skimmer.
STEP 10
You may now power up your circulation and filtration system. Make sure to use and
maintain those equipment as recommended by their respective manufacturers.
1.75’’
STEP 8
Install your circulation and filtration system, including the following minimum
equipment:
• A skimmer
• Pool pump
• Filter
• Water return
Make sure to use and maintain the equipment as recommended in their respective
manufacturers. Do not power up the equipment at this point. If the water reaches
2” bellow the water return and the above equipment is not installed, stop filling the
pool.
A basic circulation and filtration system
MUST BE INSTALLED on your pool.
Make sure you follow all local and provincial regulations
when you proceed with pool accessories installation.
The components allowing entry into the pool must be
approved for the safety of users.
IMPORTANT
IMPORTANT
INSPECTION
The parts most likely to cause a leakage problem are the skimmer and the water
return. Regularly inspect those areas of these two components to make sure there is
no water leakage on the wall of the pool. Make the necessary repairs to the
protection joints of the skimmer and water return (see replacement of these parts)
to stop any leakage as it may cause rust and seriously damage the pool wall, the
bursting of the pool that could cause significant damage to your property and/or
your neighbors.
Your pool liner must be inspected regularly for leaks. Also, inspect your wall for
corrosion and scratches. If problems are detected,
action must be taken immedi-
ately.
Small leaks or holes in the liner can be repaired easily using repair kits sold
at your dealer. Corrosion and scratches on the pool wall must be repaired by using
an anti-rust enameling product. Rub the rusted surface with a wire brush, apply the
anti-rust product and repaint the wall to match the repair to the color of the wall.
WATER CHEMISTRY
The pool water contains several corrosive products for the wall of the pool. It is
important to check that there are no leaks in the liner. Any leaks will cause corrosion
to the pool wall which, if not treated quickly, will reduce the strength of the wall.
The wall could collapse and cause significant damage to your property and/or your
neighbors and could also cause major injuries to people near or in the pool.
REGULAR CLEANING
Keep the wall and resin structure clean. Always clean chemical deposits that may
appear on exterior surfaces of the pool. Cleaning the surfaces of the pool, structure
and wall, is recommended at least once a year with a cleaning product without
bleach.
Neglecting maintenance of your pool will void the
warranty of your pool
IMPORTANT
TABLE - RECOMMENDED WATER CHEMICAL PARAMETERS
ppm = part-per-million, ppb = part per billion
This pool series is compatible with Carvin
®
Ollo™ Salt Chlorine Generator; consult the owner’s
manual for ideal pool water salinity levels.
Paramètre
Minimum
Cible
Maximum
Acide cyanurique
30 ppm
80 ppm
100 ppm
Chlore libre
1.0 ppm
3.0 ppm
Chlore combiné
(Chloramine)
0 ppm
pH
7.2
7.8
Alcalinité totale
80 ppm
120 ppm
Dureté calcique
200 ppm
300 ppm
Métaux
(Cuivre, Fer, Manganèse)
None
Nitrate
None
Phosphate
125 ppb