-3-
GREEN LED ON continuously
: GSM searching network
GREEN LED OFF
: Power off
RED LED Flash once
: uploading tracking is ok
RED LED Flash twice
: can not upload tracking
4.
Power supply
For CCTR-803BT, the tracker uses the 5V DC power supply, too high voltage or AC voltage may damage
the tracker or even cause accidents, it is necessary connecting to 5V power supply.
5.
Power Down Alarm:
When the tracker power supply is off or the voltage is too low, the GREEN LED of the tracker will flash 3
times, and then the tracker will send power down alarm SMS to the authorized number. This means the tracker
power is removed or the tracker is removed, please confirm.
Power Down Alarm
Battery:88%
6.
Back to Factory Setting
Send the SMS command to the tracker can reset the tracker setting to the factory mode (just like new
tracker). The SMS command is FACTROY*123456. FACTORY is command, 123456 is tracker password.
7.
ANTENNA
The Antenna of GSM and GPS are built in the tracker. So please leave the tracker away from big metal,
that will reduce the GSM and GPS signal.
8.
Using Condition
The working temperature is -20
℃
to 60
℃
, over this range the specification maybe can not reach the
standard level. the storage temperature can reach to -40
℃
to 80
℃
.
Simply Using Step
1. First to buy a 2G GSM phone SIM card and enable GPRS service, order a data package 20-30M
(Normally tracker will use 20M data every month), install in the tracker, please refer
Before Using 2
. Some
SIM card need send SMS to active GPRS data service, please call the SIM card supplier to confirm.
2. Connect the tracker power wire to the car battery or press the ON/OFF button till the Green LED on
continuously, the tracker is powered on, put the tracker outdoor for easy get GPS & GSM signal.
3. Check LED flash, refer
Before Using 3
for detail, If Green LED flash once means GSM and GPS
