Congratulations on the purchase
Item#
Description
Qty
of your Super Stick Hockey game!
Game set up should be near to
3
BOLT-3/8-16x1-1/2” HEX HD (09.744.24) 16
where you will play the game.
4
WASHER,FLAT 3/8” BLACK (09.755.41) 16
Select a clear level floor. The
5
LEG BOOT (05.770.40)
4
cabinet legs will be assembled
6
LEG 29” (01.744.50)
4
while game is on the side. This
8
PUCK (05.744.52)
2
is a heavy cabinet and turning it
9
DOME (05.744.54)
1
over will require at least TWO
10
UPPER CABLE
1
ADULTS.
11
CABLE CLAMP (05.744.10)
3
12
SCORING UNIT (425.00.80)
1
13
WASHER,FLAT#10 BLACK (09.770.28)
1
14
ACORN NUT (09.744.15)
1
GAME FEATURES AND PLAY
Insert (4) “AA” batteries into the battery holder. Weak batteries may cause erratic scoring. Game can be played with
or without electronic scorer. First period will commence each time reset button is depressed. Game play consists of
(3) two-minute periods and (1) one minute period in the event of a tie. Game play will end in overtime with a player
scoring. The period lights will flash at the end of the period and at the end of game. Final score will flash the game
winner. Electronic scoring will turn off automatically after end of third period.
FIGURE A
Assemble the four LEGS (item #6) using (16) 3/8-16 x 1-1/2” HEX HEAD MACHINE BOLTS (item #3) and (16)
3/8 BLACK FLAT WASHERS (item #4). Slide the (4) LEG BOOTS (item #5) over the bottom of the legs. Tighten
leg bolts.
ATTACH DOME
IMPORTANT:
Remove the blue or opaque protective film from dome prior to play. Only use glass cleaner and a soft cloth to clean
the dome to prevent scratches.
Connect the upper and lower cables. Whenever dome removal is necessary, always disconnect the (2) cables first to
prevent damaging the dome or scorer
.
FIGURE B
Attach SCORING UNIT (item #12) to DOME (item #9). Slip screw projecting from top of scoring unit through hole
on top of dome and secure with ACORN NUT (item #14) and WASHER (item #13). Attach (3) CABLE CLAMPS
(item #11) with adhesive pads to the dome opposite the large hole in the dome side and secure the UPPER CABLE
(item #10) to the clamps.
Signature Series Only:
Screw in the (8) DOUBLE HEADED SCREWS
into the bottom holes of each side & end. (The
drink holder corners have slots that will slide over
these screws.) Attach (4) DRINK HOLDER
CORNERS to each corner of cabinet by sliding
them down over the top edge of the cabinet. Attach
the drink holder corners by carefully engaging the
(2) double headed screws on the corners of the
cabinet with the slots on the inside of the corners.
Drink holder corners should fit snugly.
Face-off with PUCK (item #8) and HAVE FUN
PLAYING!
FIGURE A
3
4
5
6
10
11
9
12
14
13
07.415.10 08/14
