– 20 –
39-EN
40-EN
EN
EN
Setting the louver lock
1
Push and hold the
button (right side of
the button) for at least 4 seconds while
running is stopped.
blinks.
•
When no unit number is displayed, all units are
selected.
2
Push the
button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
The fan of the selected unit runs, and the louver
swings.
3
Push the “TEMP. ”
buttons to
display the number of the louver to fix its
direction.
The selected louver swings.
4
Push the buttons to select the
direction of the louver you do not want to
swing.
* If (4) or (5) is selected, condensation may occur
during cooling.
5
Push the
button to confirm the setting.
When the setting is confirmed, the
mark lights
up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
6
Push the
button to finish the setting.
* F1 appears in the CODE No. section on the
remote controller. This indicates that the louver
01 shown in the following figure is selected.
NOTE
Even in louver lock mode, the louver temporarily
moves in the following cases:
•
When the air conditioner is stopped
UNIT LOUVER
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
(1)
0001
(2)
0002
(3)
0003
(5)
0005
(4)
0004
0001 - 0005
(Louver position
code)
Louver No.
03
01
02
04
Refrigerant
pipe
Drain pipe
Electrical control box
Standard swing
All four louvers swing simultaneously at the same
angle.
Dual swing
Adjoining louver alternately swing horizontally and
downward.
Cyclic swing (Recommended for cooling)
All four louvers swing at different times like waves.
Swing
Horizontal
Downward
Downward
Horizontal
Downward
Downward
Horizontal
Horizontal
1115350277.indd 21
9/27/2018 8:57:14 AM
