32
INSTALLATION OF WIRED ROOM CONTROLLER
15.3 Installation Diagram
1. Connect the female joint of wires group from the main board with the male joint of
( See Fig. 1 )
2. Connect the other side of connective wires group with the male joint of wires
group leads from wired controller. ( See Fig. 1 )
Only with size indoor unit 72K
3. Take off the cover of wired controller at
the bottom with the screwdriver.
( See Fig. 2 )
4. Put the battery into the installation site
and make sure the positive side of the
battery is in accordance with the positive
side of installation site.
( See Fig. 3 )
5. Adjust the length of two plastic bolts base on the length of throughout from standard
electric cabinet to the wall. Confirm the two bolts fixing in the cabinet are in the same
length and vertical to the wall surface.
6. Fix the bottom cover to the electric cabinet by the accessory slotted head screws.
Confirm the bottom cover is parallel to wall surface. And then reinstall the bottom cover
to wired controller. ( See fig. 4 )
NOTE
Over tighten the screw would cause rear cover deformed and LCD damage.
When installation, please maintain the screws and wired controller at the same height level without deformed.
When installation, please reserve a certain length of wired controller connective cable for future maintenance to
take off the wired controller.
Connection cable of wired
controller (accessory)
Main Board of
Indoor Unit
Fig (1)
Wired Controller
Wires Group From
Wired Controller
Wires Group From
Main Board
!
Fig (4)
Fig (2)
Fig (3)
The rear side of
wired controller
Shielded 4-core cable
Indoor unit electric cabinet
Main board
2 wire cable
Display & receiver panel
Summary of Contents for ClassiCool 53KDMT12N-718
Page 87: ...83 Notes...
Page 88: ......