![background image](http://html1.mh-extra.com/html/carrier/a180218c/a180218c_installation-instructions-manual_2562410017.webp)
7
4.2.
Check Equipment
Inspect equipment. File a claim with shipping company prior to installation if
shipment is damaged or incomplete.
4.3.
Location
ELECTRICAL OPERATION HAZARD
Failure to follow this warning could result in personal injury
or death.
Disconnect power before routing control wiring.
!
WARNING
All wiring must comply with national, state, and local codes.
4.3.1.
Wall Control
The Infinity System Control is the command center for the Infinity System. It
should be located where it is easily accessible and visible to the adult homeowner
or end user. For accurate temperature measurement, the following guidelines should
be followed:
The Infinity System Control, Remote Room Sensors and Smart Sensors
SHOULD
be mounted:
S
Approximately 5--ft (1.5 m) from the floor.
S
Close to or in a frequently used room, preferably on an inside partitioning wall.
S
On a section of wall without pipes or ductwork.
The Infinity System Control and Sensors
SHOULD NOT
be mounted:
S
Close to a window, on an outside wall, or next to a door leading to the outside.
Summary of Contents for A180218C
