11
Step 6 — Adjust Factory-Installed Options
APOLLO CONTROL — The optional Apollo control is used
to actively monitor all modes of operation as well as indoor
(evaporator) fan status, filter status, and indoor-air quality. The
Apollo control is designed to work with Carrier TEMP and
VVT
®
systems.
The thermostat must be wired to the Apollo control before
starting the unit. Refer to the Apollo control installation
instructions for information on installing the thermostat. See
Fig. 13 for Apollo location.
MANUAL OUTDOOR-AIR DAMPER — The outdoor-air
hood and screen are attached to the basepan at the bottom of
the unit for shipping.
MAIN
CONTROL
BOX
BOX
SINGLE
POINT BOX
MOUNTING SCREW
DISCONNECT
MOUNTING
LOCATION
EMT OR RIGID
CONDUIT
(FIELD SUPPLIED)
BRACKET AND
CONDUIT DRIP
BOOT
CENTER
POST
COM-
PRESSOR
NO. 1
SINGLE
POINT
COM-
PRESSOR
NO. 2
Fig. 9 — Conduit Installation
EMT — Electro-Metallic Tubing
Fig. 10 — Typical Component Location
LEGEND
NOTE: Connect W2 when 2-stage accessory electric heaters are
used.
Fig. 11 — Low-Voltage Connections
AHA — Adjustable Heat Anticipator
CC
— Cooling Compensator
Field Wiring
Factory Wiring
RACEWAY
HOLE IN
END PANEL
(HIDDEN)
Fig. 12 — Field Control Wiring Raceway
CONTROL
WIRING
APOLLO
CONTROL
WIRING TO
THERMOSTAT
COMPRESSOR
NO. 2
COMPRESSOR
NO. 1
Fig. 13 — Apollo Control Factory-Installed in
Typical Unit
Summary of Contents for 50TFF008-014
Page 43: ......