![background image](http://html1.mh-extra.com/html/carrier/50sd024/50sd024_installation-instructions-manual_2561615001.webp)
1
50SD
Legacy
t
Single--Packaged Air Conditioner System
With R--22 Refrigerant
Single-- and Three--Phase Units Sizes 024--060
Installation Instructions
NOTE
: Read the entire instruction manual before starting the
installation.
NOTE
: Installer: Make sure the Owner’s Manual and Service
Instructions are left with the unit after installation.
TABLE OF CONTENTS
Page
SAFETY CONSIDERATIONS
1
. . . . . . . . . . . . . . . . . . . . . . . .
INTRODUCTION
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RECEIVING AND INSTALLATION
2--9
. . . . . . . . . . . . . . . . .
Check Equipment
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Identify Unit
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inspect Shipment
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Provide Unit Support
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Roof Curb
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Slab Mount
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Ground Mount
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Provide Clearances
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Field Fabricate Ductwork
2
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Rig and Place Unit
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inspection
2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installation
6
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Use of Rigging Bracket
6
. . . . . . . . . . . . . . . . . . . . . . . . . . .
Connect Condensate Drain
7
. . . . . . . . . . . . . . . . . . . . . . . . . .
Install Duct Connections
7
. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Configuring Units for Downflow (Vertical) Discharge
7
. . . . .
Install Electrical Connections
8
. . . . . . . . . . . . . . . . . . . . . . . .
High--Voltage Connections
9
. . . . . . . . . . . . . . . . . . . . . . . .
Special Procedures for 208v Operation
9
. . . . . . . . . . . . . . .
Control Voltage Connections
9
. . . . . . . . . . . . . . . . . . . . . . .
Standard Connection
9
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Transformer Protection
9
. . . . . . . . . . . . . . . . . . . . . . . . . . .
PRE--START--UP
10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
START--UP
10
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Check for Refrigerant Leaks
10
. . . . . . . . . . . . . . . . . . . . . . . .
Start--Up Adjustments
12
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Checking Cooling Control Operation
12
. . . . . . . . . . . . . . .
Checking and Adjusting Refrigerant Charge
12
. . . . . . . . . .
Indoor Airflow and Airflow Adjustments
17
. . . . . . . . . . . .
Cooling Sequence of Operation
17
. . . . . . . . . . . . . . . . . . . .
MAINTENANCE
18--19
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Air Filter
18
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Indoor Blower and Motor
18
. . . . . . . . . . . . . . . . . . . . . . . . . .
Outdoor Coil, Indoor Coil, and Condensate Drain Pan
19
. . . .
Outdoor Fan
19
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Electrical Controls and Wiring
19
. . . . . . . . . . . . . . . . . . . . . .
Refrigerant Circuit
19
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Indoor Airflow
19
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Metering Devices–AccuRater
®
Piston
19
. . . . . . . . . . . . . . . .
TROUBLESHOOTING
19
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
START--UP CHECKLIST
19
. . . . . . . . . . . . . . . . . . . . . . . . . . .
C99001
Fig. 1 -- Unit 50SD
SAFETY CONSIDERATIONS
Installation and servicing of this equipment can be hazardous due to
mechanical and electrical components. Only trained and qualified
personnel should install, repair, or service this equipment.
Untrained personnel can perform basic maintenance functions such
as cleaning and replacing air filters. All other operations must be
performed by trained service personnel. When working on this
equipment, observe precautions in the literature, on tags, and on
labels attached to or shipped with the unit and other safety
precautions that may apply.
Follow all safety codes. Installation must be in compliance with
local and national building codes. Wear safety glasses, protective
clothing, and work gloves. Have fire extinguisher available. Read
these instructions thoroughly and follow all warnings or cautions
included in literature and attached to the unit.
Recognize safety information. This is the safety--alert symbol
.
When you see this symbol on the unit and in instructions or manuals,
be alert to the potential for personal injury. Understand these signal
words: DANGER, WARNING, and CAUTION. These words are
used with the safety--alert symbol. DANGER identifies the most se-
rious hazards which
will
result in severe personal injury or death.
WARNING signifies hazards which
could
result in personal injury
or death. CAUTION is used to identify unsafe practices which
may
result in minor personal injury or product and property damage.
NOTE is used to highlight suggestions which
will
result in en-
hanced installation, reliability, or operation.