
26
m3/h
mbar
GAS INFORMATION
COUNTRY
GAS
CATEGORY
PIN
CONSUMPT.
PRESSURE
TYPE
WO
12.8 Pre-assembly roofcurb
The 50EN/EH unit can be attached to a standardised pre-
assembly roofcurb with adjustable height, built in galvanised
steel panelling with polyester paint and thermal insulation.
12.7 Gas burner
● Natural gas or propane gas burner with proportional actuator
0-10V designed in accordance with the standards in force in
compliance with the Gas Directive 90/396 EEC.
EC certifi cation: 0694CP1457.
● The electronic control of the 50EN/EH unit will only be
managed by the burner connection as support for the heating
depending on ambient conditions. The control will also receive
from the burner a safety signal in the event of failure.
● The burner module is fi tted with a controller installed inside
as standard. This controller is used to manage, confi gure and
diagnose all the operating parameters and safeties in the
burner.
The burner module includes a name plate featuring the main
gas characteristics as well as the 50EN/EH unit serial number
on which it is to be mounted.
Important: All the necessary information about the
installation, commissioning and maintenance of the burner
module is available in the specifi c instruction brochure on
gas burner No. 09.100, as well as in the manufacturer’s
(APENGROUP) installation and maintenance brochure
for the burners in the PCH series (both supplied with the
burner).
The serial number must be used in all communication
regarding the unit.
50EN/EH unit
identi
fi
cation No.
50EN/EH unit with
burner CE certi
fi
cate No.
Burner
model
Important: All the necessary information about the
installation of the roofcurb is available in the specifi c
instruction brochure on roofcurb No. 12.62 (supplied with
the roofcurb).
The following image shows a detail of the installation of the
roofcurb on a roof. The levelling system uses angle pieces that
allow adjustments in the X and Y axes.
The roofcurb is supplied thermally isolated, the installer must
only do a sealing upsweep around the roofcurb to ensure that
water does not penetrate the roof.
12 - FACTORY OPTIONS AND ACCESSORIES
Summary of Contents for 50EH 1100
Page 35: ......