![background image](http://html1.mh-extra.com/html/carrier/38glp-g/38glp-g_installation-manual_2560635009.webp)
38GLP---G / 38GLP---G9
GB - 8
Refrigerant connections
Air purging
Use only a vacuum pump to purge air from the piping.
NEVER use the system compressor as a vacuum pump.
NEVER use the unit refrigerant gas to purge the connecting
pipes.
No additional refrigerant has been provided in the unit for this
purpose.
TRemove the caps from the two and three-way valves.
Create a vacuum with a vacuum pump connected to the service
connection of the suction shut-off valve, as shown, keeping the
shut-off valves completely shut until a 50 Pa (0.5 mbar) vacuum has
been reached.
Now open the two-way valve for 3 sec., then quickly shut it to check
for possible leaks. After the leak check, fully open the two and
three-way valves.
Replace caps and check for leaks.
헀
헁
헂
Cooling (2)
Maximum conditions
outdoor temperature 43
°
C
indoor temperature 32
°
C d.b.; 23
°
C w.b.
Minimum conditions
outdoor temperature-15
°
C
(3)
indoor temperature 21
°
C d.b.; 15
°
C w.b.
Mains power supply
Nominal single-phase voltage
230V ~ 1pH 50Hz
38GLP---G
Operating voltage limits
min. 198V – max. 264V
Mains power supply
Nominal three-phase voltage
400V 3N ~ 50Hz
38GLP---G9
Operating voltage limits
min. 342V – max. 462V
Table III: Operating limits
(1)
Notes:
1. Data referred to the outdoor unit only.
2. According to ISO 5151.2/T1.
3. The 38GLP units are fitted with Head Pressure
Controller and can operate at an outside temperature
up to –15
°
C.
햹
Gas line (large diameter)
햺
Liquid line (small diameter)
햻
Flare nut
햽
Indoor unit
햾
Outdoor unit
햿
Vacuum pump
햳
Three-way valve
햴
Needle valve
햵
Valve cap
햶
Valve needle
햷
Two-way valve
햸
Allen (hex. head) wrench
헀
Pipe
헁
Pipe insulation
헂
Fastening tape
햿
햽
햾
햺
햹
Once all connections have been completed, check for leaks by
using a leak detector specific for HFC refrigerants.
Finally wrap the valves and pipes with anti-condensate insulation
and tighten this with tape, without exerting too much pressure on
the insulation.
Repair and cover any possible cracks in the insulation.
Fix the pipes to the wall with hooks or conduits.
d.b. - dry bulb w.b. - wet bulb