8 Garrett Metal Detectors
AT Gold
™
9
ASSeMBly
1. Holding the upper and lower stem assembly in front of you (as
shown below), twist camlock to the right (clockwise) to loosen.
2. Slide lower stem out to engage spring clips in upper stem holes.
3. Align the holes in the mounting washers with the small posts on
the lower stem and press firmly into place.
7. Depress the spring clip in the S-stem (containing control housing)
and insert S-stem through the upper camlock collar into the
upper stem.
8. The spring clip must be engaged in the FIrST stem opening in
order to maintain battery compartment access. Hand-tighten
the camlock collar. Do not overtighten!
9. Depress the spring clip in the lower stem and adjust to the most
comfortable operating length. Hand-tighten the lower stem
camlock collar. Do not overtighten!
10. Wrap the cable snugly about the stem with the first turn of the
cable over the stem.
11. Insert the coil connector into the 4-pin connector of the control
housing and hand-tighten. After lining up the connector
pins, press the connector in firmly, yet carefully, until the O-ring
is felt to be fully inserted.
Note: If the O-ring is properly
seated, the connector's collar
can be easily tightened; if the
collar is difficult to turn, the
O-ring may not be seated
properly.
4. Slide the searchcoil onto the stem.
5. Insert the threaded bolt through the holes of the lower stem and
searchcoil. Hand-tighten searchcoil assembly with the wing nut.
6. Holding assembly as shown, loosen camlock at the end of the
upper shaft by turning counter-clockwise.
Note: If the camlock collar slides off during loosening, simply
slide it back on and tighten slightly.
1.
2.
3.
4.
5.
6.
7.
8.
1st pin position
9.
10.
11.