26
4.2 Using the door in the box
For safety purposes, the lock on the outside of the box has been placed relatively low, which makes it
very hard for children to open the door when they are strapped in the safety threepoint belts. Besides,
the door is equipped with a second safety lock on the inside of the door.
●
Only open the door when the bike stands still and on the prop stand on a stable surface.
●
Only open the door if the surroundings allow to get off safely.
●
You can open the door by using the door handle, which is located on the outside of the box.
●
Additionally use the second lock, which is located on the inside of the box. It’s impossible for
children to open the door, when they are using the safety belts properly.
4.3 Cleaning the box
The cleaning frequencies are guidelines. The frequency can be adjusted based on the circumstances.
For light forms of pollution, use water with a standard cleanser, with a sponge or a non-abrasive nylon
brush. In areas with normal contamination cleaning is advised at least once a month. Using the bike in
areas with a higher degree of pollution, like city centers, industrial areas, airports, are advised to clean
the box twice a month.
The cleanser must meet the following criteria:
●
No abrasive effect, low alkaline or acidic (a pH value between 6 and 8).
●
Free from strong solvents or alcohol, these substances can damage the film.
●
The water must not be warmer than 80 °C/176 °F.
If you want to use cleaning with the help of high pressure, consider the following:
●
Maximum water temperature: 80 °C/176 °F.
●
Minimum distance: 30 cm away from the object.
●
Maximum pressure of the water jet: 80 bar/1160 Psi.
●
Spray angle: Always aim the water jet at the object at an angle of 90 degrees.
●
Never aim the water jet completely flat on the edges of the object.
4.4 Small scratches in the foil
Small scratches in the foil can in many cases be removed by heating with a warm blower. Note: The
temperature of the surface to be treated must not exceed 50 °C. Besides, don’t move the blower closer
by then 10cm from from the foil to prevent melting of the foil.
●
The best effect is achieved by constantly moving the blower back and forth above the scratches.
●
Do not keep the blower too long at one specific point of the object. This may cause damage to the
surface.
●
For larger deep scratches it is advisable to have the foil on that part possibly replaced. Contact a
specialized wrapper if replacement is desired.
