• LED indicator: Place the LED indicator on the dashboard where it can be seen from outside the car and from
the driver seat. Connect the indicator to the brain unit.
• Siren: Place the siren on a non accessible place, e.g. under the hood. Place the siren with the opening fac-
ing down because of water. Use one of the screws for the mass connection. Connect the siren to the brain
unit.
• Reset switch: Place the reset switch on a non visible position but accessible from the driver seat. Connect
the reset switch to the brain unit.
• Shock sensor: Place the shock sensor on an accessible place because of adjusting its sensitivity. Place the
sensor as tightly as possible on a solid base of the car so vibrations can be picked up by the sensor. Connect
the sensor to the brain unit. The sensitivity was set by our factory. It is suggested not to change it if not
necessary.
• Shock sensor adjustment: There is a LED in the shock sensor that will flash when the sensor is triggered.
You can adjust the sensitivity with a screwdriver. Turn to the right (H) to make the sensitivity higher. Turn
to the left (L) to make the sensitivity lower.
• Microwave sensor (optional): Place behind a plastic panel or behind lining but keep it accessible because
of adjusting. Do not place the microwave sensor on metal. Connect the sensor to the brain unit.
CONNECTING WIRES AND PLUGS
1. Determine the position of the brain unit, but don’t attach it yet.
2. Determine the position of the LED indicator and the reset switch. Attach both and conduct the wires to the
brain unit.
3. Determine the position of the shock sensor, microwave sensor and the ultrasonic sensor and conduct the
wires to the brain unit.
4. Find a good mass (-) and connect the black wire (of the 12-pole plug) to it.
5. Find a constant plus (+12V) min. 15Amp and connect the red wire (of the 12-pole plug) to it.
6. Place the siren and connect the mass. Conduct the wire (+) to the brain unit en connect it to the pink wire
(of the 12-pole plug).
7. Find the left and right feed wire of the flashlights. Connect these wires to the brown wire (of the 12-pole
plug) 2 x (1 x left, 1 x right).
8. Find a ACC plus (+12V) when the key is in the ACC On position and connect the white wire (of the 6-pole
plug) to it.
9. Couple the plugs. First the 12-pole plug, then the 4/3-pole plug (shock, ultrasonic and microwave sensor),
then the 6-pole plug, then the 2-pole plug (LED indicator and reset switch).
INSTALLING CENTRAL DOOR LOCKING SYSTEM
1. The car has a central door locking system. Please judge if it is a negative or positive trigger.
2. The car has a central door locking system, but the command door does not have a motor (the other three
have motor). As long as the command door gets a motor installed it can work. See picture 4 for reference.
3. The car has a pneumatic central door locking system and it has a pneumatic and electric lock option. Con-
nect the wire to input of the pneumatic lock to activate it. See picture 5 for reference.
4. If the car does not have a central door locking system, please install one. See picture 2 for reference.
Summary of Contents for 0260060
Page 2: ......
