16
PRE-FILTER CLEANING
Retaining
Ring
Pre-filt er
Pre-Filter
Large
Tab
Pre-Filter
PRE-FILTER CLEANING
Retaining
Ring
Pre-filt er
Pre-Filter
Large
Tab
Pre-Filter
How to Replace the Vacuum Filters
The pre-filter is located inside the dustbin. Check
the pre-filter frequently and clean when dirty.
1. Remove the dustbin from
the vacuum cleaner.
7. Rinse with cold water only
DO NOT
use
detergent or soap. Allow parts to dry 24
hours before putting themback into the
vacuum cleaner.
2. Rotate the dustbin
lid from lock to
unlock position
(Fig. 1).
3. Separate the dustbin
lid by pulling down
(Fig. 2) and lift off.
1. Slide the pre-filter
upward onto the
dustbin lid body.
Align large tab
with large slot
(Fig. 6).
2. Slide the
retaining ring
into position.
Align the large
tab with the
large slot. Rotate
as indicated by
the arrow
(Fig. 7).
3. Replace the
lower portion of
the dustbin by
aligning marks as
UNLOCKED.
4. Rotate until marks
align as LOCKED
(Fig. 8).
5. Replace the
dustbin into the
vacuum cleaner.
4. Remove the
retaining ring
by turning in
the direction
indicated by the
arrow (Fig. 3).
5. Remove the
pre-filter
by sliding
downward
(Fig. 4).
6. Clean the pre-filter by
gently tapping over
a trash container.
Tap on several sides
to ensure thorough
cleaning (Fig. 5).
How to Clean the Pre-Filter
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
DO NOT wash pre-filter in the dishwasher.
DO NOT install damp parts into the vacuum
cleaner
To Replace the Pre-Filter
