7800-25 Series Operations Manual
Rev B 11-10-2020
Page 11 of 56
INSTALLATION
Unpacking
Your new unit has been thoroughly packaged to avoid shipping damage. However, the
unit should be fully inspected upon arrival before signing for receipt. If the package has
visual damage, notes should be made on the freight bill and signed by the delivery
company. In the event of concealed damage after the unit is uncrated, keep the carton
and packaging material. Call the shipping company within 7 days of receipt, request
inspection and retain a copy of the inspection report.
For prolonged periods of inactivity leave the unit unplugged and securely stored.
Caron provides full on-site installation services for all models. Our installation services
guarantees the proper set-up and startup of all equipment. Please contact the Service
Department at 740-373-6809 or
For detailed instructions on how to safely remove the chamber off the shipping pallet,
see document located on the chamber.
Choosing a Location
To ensure proper operation, the unit must be located on a firm level surface, capable of
supporting approximately 600 pounds. The
unit should be located in an 18°C to 25°C
ambient area and where there is no direct airflow from heating and cooling ducts as well
as out of direct sunlight.
Allow four inches of clearance on all sides of the product to
allow for connections and airflow. The unit is designed to be used under the following
conditions:
Indoor use only
Altitude up to 2000m.
Maximum relative humidity: non-condensing
Mains supply voltage fluctuations up to +/- 10% of the nominal voltage;
damage may occur if voltage varies more than 10%
Transient overvoltages up to the levels of overvoltage category II
Temporary overvoltages occurring on the mains power supply
Pollution degree: 2
Ingress protection: IPXO
This product weighs in excess of 600 pounds.
Ensure that sufficient resources are available to
safely move the product.
