INVISI
™
SERIES II
INVISI
™
SERIES II
Servicing - Inlet Valve
Helplines
5
3
4
1
2a
2b
A
A
D
C
B
A
C
B
Maintenance & Spare Parts Instructions
Wash seal to remove any dirt and inspect
for damage.
Remove seal from Cap Assembly.
Replace seal onto cap assembly.
If necessary replace cap & Seal (Spare Part
Kit 687 049).
Push & rotate counter-clockwise to re-
attach cap assembly, re-clip Adjustment
Screw and re-fit into tank.
Adjustment
Screw
To clean and inspect seal
:
Unclip the Adjustment Screw, rotate
clockwise & pull to remove cap assembly.
To replace complete Inlet Valve
:
Rotate nut clockwise & pull to disconnect
it from the Bracket.
Cap
Assembly
Bracket
Inlet
Valve
15
• Inlet Valve is slow to fill OR fails to open ► Ensure tap is open.
• Inlet Valve fails to close ► Clean & inspect seal as described above, replace Cap Assembly
& Seal if damaged.
• If any other issues arise ► Consult a plumber or Caroma After Sales Service.
• Inlet Valve Seal may require periodic cleaning (dependant on water quality).
Procedure as defined below.
Servicing Requirements
Troubleshooting Guide
• Caroma Invisi II Inlet Valve compatible Spare Part Kits are:
687 171
Containing -
1 x Complete Unifill Inlet Valve
-
with bayonet connection
687 049
Containing -
1 x Cap Assembly
-
1 x Seal with Lever
687 040D
Containing -
Seal only
Refer to
Maintenance & Spare Parts Instructions
Spare Parts Information
687 049
Cap Assembly
687 040D
Seal
Ensure water is turned off and remove Inlet
Valve from tank as per the instructions on
page 13.
687 040D
Seal
