INVISI
™
SERIES II
1
2
1
2
3
Preparation for Fitout
OR
1
2
3
OR
OR
1
2
3
OR
1
2
Cement or fibro sheet
Plywood
Tile
12
Pneumatic Tube Connections
Direct Panel Mounting
Remote Panel Mounting
Remote Button Mounting
Options for Finishing Around the Flush Pipe
Bowl Bracket
Ensure the Wall Hung Bowl Mounting Bolts, Flush Pipe and Waste Pipe
are all set to the correct height and spacing to suit the selected bowl.
When finishing the wall clad and tile right up to the edge of these parts.
The Caroma Cube and Walvit are the only bowls currently approved to be
used with the Invisi bracket
Attach the tubes to the tank as shown above. Break out tab in the Top
Panel or Dust Cover Panel to allow the Tubes to protrude and clip back
into position. Feed Pneumatic Tubes through the framework and out
through the Drilled Holes. Apply tape over end of tubes to prevent any
dirt from getting inside and tuck neatly back inside holes.
Attach the tubes to the tank as shown above. Break out tab in the Top
Panel or Dust Cover Panel to allow the Tubes to protrude and clip back
into position. Feed the 4m lengths of Pneumatic Tube through the frame-
work and out through the Mounting Box. Apply tape over end of tubes
to prevent any dirt from getting inside and tuck neatly back inside the
Mounting Box. When finishing the wall clad and tile right up to the edge
of the Access Window and or Remote Mounting Box.
Cut Pneumatic Tube in half so you have 2 x 9.8" (0.25m) lengths (ensure a straight
clean cut to tube). Attach the tubes to the tank as shown above. Tuck neatly back
inside the Access Window and clip the dust cover panel back into position. When
finishing the wall, clad and tile right up to the edge of the Access Window.
Firmly connect the pneumatic tube into the half and full flush positions.
Each tube should be inserted approx. 0.6" (16mm) until it hits a stop.
NOTE:
• 4.8/3L Tanks are supplied with 19.7" (0.5m)
length pneumatic tube.
• Remote Mounting Box Kit is supplied with 2 x 4m
lengths of pneumatic tube.
• 4m lengths of pneumatic tube can be purchased
separately. Part No. 237 702.
For instructional videos, please visit www.caromausa.com