5
Carolina Cooker®
844-478-4334
Model M107828
June 2021
3.4 LP (Propane) Gas Supply Connection
1.
The tank valve should be in the “OFF” position. If not,
turn the knob clockwise until it stops.
2.
Make sure all burner valves are in the “OFF” position.
3.
Always connect the gas supply regulator as follows:
Insert the regulator inlet into the tank valve and turn the coupling nut clockwise until
the coupler tightens up (see picture). Do not over tighten the coupler. Turn the main
tank valve on and turn the burner control valves on the unit to the “HIGH” position for
about 20 seconds to allow the air in the system to purge before attempting to light
the burners.
WARNING:
Always take a leak test before lighting the 2 X 4 Grill to prevent a possible fire or explosion. Never store
a spare propane cylinder in the vicinity of this 2 X 4 Grill, or in the vicinity of any other potential heat source.
3.5 LP Gas Supply Cylinder Disconnection
1.
Turn the burner valves off.
2.
Turn the tank valve off. (Turn clockwise to stop).
3.
Detach the regulator assembly from the tank valve by turning the quick coupling nut counterclockwise.
3.6 LP Tank Removal, Transport and Storage
•
Turn OFF all control knobs and LP tank valve. Turn coupling nut counterclockwise by hand only - do not use tools to
disconnect. Lift LP tank wire upward off of LP tank collar, then lift LP tank up and off of support bracket. Install safe
-
ty cap onto LP tank valve. Always use cap and strap supplied with valve. Failure to use safety cap as directed may
result in serious personal injury and/or property damage.
•
A disconnected LP tank in storage or being transported must have a safety cap
installed (as shown). Do not store an LP tank in enclosed spaces such as a
carport, garage, porch, covered patio or other building. Never leave a LP tank
inside a vehicle which may become overheated by the sun.
•
Do not store LP tank in an area where children play.
3.7 LP Tank Filling
•
Use only licensed and experienced dealers.
•
LP dealer must purged tank before filling.
•
Dealer should NEVER fill LP tank more than 80% of LP tank volume. Volume of propane in tank will vary by
temperature.
•
A frosty regulator indicates gas overfill. Immediately close LP tank valve and call local LP gas dealer for assistance.
•
Do not release liquid propane (LP) gas into the atmosphere. This is a hazardous practice.
•
To remove gas from LP tank, contact an LP dealer or call a local fire department for assistance. Check the
telephone directory under “Gas companies” for nearest certified LP dealers.
3.8 LP Tank Exchange
•
Exchange your Type 1 cylinder with OPD safety feature-equipped ONLY.
•
Always keep new and exchanged LP tanks in upright position during use, transit or storage. Leak test new and ex
-
changed LP tanks BEFORE connecting to burner.