Owner’s Manual |
R829
9
Carmanah Technologies Corp. Copyright © 2006
Document number: MAN_ROAD_R829 Owner's Manual 37234_vC
Last revised: November 7, 2006
4.9
Erect the Pole
Assuming that the pole base is already in place, stand the pole upright and bolt it to the base
using the mounting hardware (see Figure 9).
4.10
Install the Upper Signal Head
Loosen the bolts, which hold the top cap to the pole so that the top cap can be rotated. Open the
cover of the top signal head and install the unit onto the upper elbow as shown in Figure 10.
Hand-tighten the nut for now.
Locate the bottom bracket as shown in Figure 11 and, as with the top elbow, tighten the nut finger
tight for now. The bottom bracket can be fastened to the pole with bolts or stainless steel straps.
Connect the signal wire from the head assembly to the signal head and close the cover.
4.11
Installing the Lower Signal Head (if equipped)
The wire for the lower signal head should already be hanging out of the hole in the pole. Feed
the wire through one of the brackets and fasten the bracket to the pole with bolts or stainless
steel straps.
Figure 8
Figure 9
Figure 10
Figure 11
Upper Elbow
Summary of Contents for R829
Page 2: ......
