Owner’s Manual | Model 502
13
© 2008 Carmanah Technologies Corporation
Revised: August 2008
7.0 Appendices
Appendix A: Original Infrared Programmer
All functions of the Model 502 light are controlled by an infrared programmer. Carmanah currently
supports both the original and the updated infrared programmers. The only differences between the two
programmers are the faceplate and setting up the programmers; all other functionality remains the same.
Table 7-1: Programmer Buttons
describes the buttons for the original Carmanah programmer.
See section
3.0 Programming a Light
for the light programming procedures.
Table 7-1: Programmer Buttons
Button or Symbol
Description
|
Use the OFF-ON button to initiate a programming sequence.
S
Use the Channel Up button to end a programming sequence.
This symbol indicates that a numerical entry is required.
A-1:
Setting up the Programmer
The light is not required to be present when setting up the programmer. Perform the following steps to
setup the infrared programmer:
1. Install two AAA batteries.
2. Press and hold the Code Search button until the red indicator light lights up, then release the Code
Search button.
3. Press and release the TV button. The indicator light will blink and then remain lighted.
4. Enter code 0 0 6 using the number buttons. The indicator light will turn off.
The remote is now ready to use for programming the light.
Whenever batteries are replaced in the programmer, you need to set-up the
programmer again using steps 2 to 4 above.
If the light does not respond to the programmer, remove and re-install the batteries and set-up the
programmer again.
Summary of Contents for 502
Page 1: ...OWNER S MANUAL Model 502 Solar LED Light ...
Page 2: ......
