Carmanah 502, Owner'S Manual

Page: 6 / 16

Owner’s Manual | Model 502
6
© 2008 Carmanah Technologies Corporation
Revised: August 2008
3.0 Programming a Light
You can customize the light settings using the programmer. Before programming the settings you must
transition the light and enter the security code. You can then program the settings listed in
Table 3-1:
Programmable Settings .
Table 3-1: Programmable Settings
Setting Section
Change the flash pattern 3.4
Set automatic light control 3.5
Turn the light off:
Storage
mode
4.1
Sleep mode 4.2
Turn the light on 4.3
3.1 Transitioning the Light
To make any change to the settings of the light, you must transition the light from night to day mode. The
light only accepts programming commands while it is exposed to light. The light cannot be programmed in
darkness. After transitioning the light you must enter the security code in order to proceed with the
programming; see section
3.3 Entering the Security Code .
If, after transition, the light does not respond to the programmer, remove and re-install the programmer
batteries and repeat the programming instructions for the required function.
Transition a new light:
1. Remove the light from the shipping box and place it in full sunlight or under an incandescent light for
at least 3 seconds.
2. Move the light into darkness and wait 3 seconds.
3. Move the light back into the light.
4. While the light is exposed to the light, point the programmer at the light and press the Start button;
when the light responds with a flash, it is ready for programming.
Transition an installed light:
During the day:
1. Cover the light with an opaque material for at least 3 seconds.
2. Uncover the light.
3. While the light is exposed to the light, point the programmer at the light and press the Start button;
when the light responds with a flash, it is ready for programming.
At night:
1. Force a transition to day by placing the light under an incandescent light for at least 3 seconds.
2. While the light is exposed to the light, point the programmer at the light and press the Start button;
when the light begins to flash, it is ready for programming.
3.2 Programming Sequence
The infrared sensor in the light responds to commands from the programmer for 1 minute after transition
of the light. The infrared sensor switches off automatically after 1 minute to conserve power.