P a g e |
43
7.3.4 Power cycle and reconnect to the Merlin LT
Having changed the IP addresses of the Merlin LT and of the PC, power cycle the Merlin LT by disconnecting and
then reconnecting the power source.
By power cycling the system, communications to the PC will be lost and a reconnection occurs using the new IP
addresses.
In the Merlin diagnostic tool, the
Please power cycle the Merlin LT system
…message window is still visible.
Tick the check box beside the statement ‘
I confirm my computer’s IP address is on the same subnetwork as Merlin’
.
Tick the check box beside the statement
‘I confirm I have power cycled the Merlin’
.
Click
OK
to return to the main Merlin diagnostic tool window.
Note: when you click
OK
, the connection with the Merlin LT is lost. It could take up to two minutes for the LAN
connection to re-establish.
The system must be reconnected by clicking
Connect
, as described in section 7.3.1.
The
Status: Idle
message is displayed: see Figure 30.
If you have changed the IP address of the Merlin from the default, factory-set value, make sure you note the new
IP address and make all users aware of the change. If you contact Carlson for support, detail the changed IP
address to your support contact.
Figure 35 Confirm you have power cycled the Merlin LT
