13
V1.3 | NRG PROFINET User Manual | © 2020 | CARLO GAVAZZI LTD.
EN
4.4
Configuration Parameters
The configuration parameters are directly assigned to the respective modules and are set during device
configuration. They are transferred automatically on start-up and during re-parameterization. All configuration
parameters can be reassigned via an acyclic command, check Communications section for further information
Parameter
Description
Values
Monitoring
parameters
Hold Current Period
Set the no. of cycles over which
the Hold Current Reading is
calculated
1
–
32
18 (default)
Alarm Settings
Alarm Recovery Mode
Set the alarm recovery mode
Manual /
Automatic
(default)
Over Voltage limit
Set the over and under voltage
limit if desired which will trigger an
alarm if the voltage reading is
beyond the range
Under voltage limit
–
660V
Default (660V)
Under Voltage limit
0
–
Over voltage
limit
Default (0V)
Over Current limit
Set the over and under current
limit if desired which will trigger an
alarm if the current reading is
beyond the range
Under current limit
–
default value
(RG..N
dependent)
Under Current limit
0
–
over current
limit
Default (0A)
Over Frequency limit
Set the over and under
frequency limit if desired which
will trigger an alarm if the
frequency reading is beyond the
range
Under frequency
limit
–
66Hz
Default (66Hz)
Under Frequency limit
44
–
Over
frequency limit
Default (44Hz)
Over Temperature
pre-warning
Δ temperature from max at
which the RG..N will issue an
alarm
0
–
50degC
Default (0dC)
Control
parameters
Switching modes
Set the firing mode that the RG..N
shall use at the output
External /
ON/OFF (default) /
Burst /
Advanced full
cycle /
Distributed full
cycle
Timebase
Set the desired timebase. (only
applicable for Burst firing mode)
0.1
- 10s
0.1s (default)
Substitute output mode
Set the output mode to be used
in case of a communication
timeout
Clear output /
Hold output
(default) /
Set Value
Substitute output value
Set the % control level to be used
in case of a communication
timeout. (Only
applicable for ‘Set
Value option’ for Output
substitute mode
0
–
100%
Default (0%)
