Service Manual
36
Cut is too far right:
Move the flexible cutter ledge (D) to the front and turn the adjusting screw (E) in clockwise direction
until the correct value is reached. Close again the cutter ledge.
Screw again the counter nut at the rear of the adjusting screw (E).
Install again front shaft, front sheet and the small front panel.
Test the function of the cutter unit.
Flexible cutter ledge (D) pushes against cutter ledge (C):
Move the flexible cutter ledge (D) to the front and turn the adjusting screw (E) anticlockwise until the
correct value is reached.
Screw again the counter nut at the rear of the adjusting screw (E).
Install again front shaft, front sheet and the small front panel.
Test the function of the cutter unit.
Summary of Contents for Vario II series
