Carl Goldberg Products decathlon arf, Owner'S Manual

Page: 5 / 29

AILERON SERVO INSTALLATION
Note: The following pictures may not exactly match
the hardware you are using. Always check the radio
manufacturer's instructions when installing radio
equipment.
1.
!
Collect the following items:
(1) Aileron servo door
(2) 3/8 x 3/4" Servo mounting block
(4) Servo mounting screw (supplied with radio)
(4) #2 Washer
(4) #2 x 3/8" Screw
(1) Servo with rubber grommet
2.
!
With the servo door upside down on the work
surface, place the servo on top of the door
with the servo arm post centered vertically
and horizontally with the servo door notch.
!
Mark the location of the servo, as shown.
!
When the epoxy is dry, drill 1/16" holes into
the servo blocks and, using the screws sup-
plied with the radio, mount the servo onto the
blocks.
4.
!
Place the servo door on the wing and drill a
1/16" hole on each corner.
!
Using the #2 x 3/8" screw and #2 washer
supplied with this kit, screw the door to the
mounting plate.
5.
!
Repeat the above steps for the second
aileron servo.
5
3.
!
Remove the servo from the door.
!
Spread epoxy on the servo mounting blocks
and, making sure the wood grain on both
mounting blocks runs vertically, glue the
blocks in place along the marks just made.
AILERON CONTROL HORN INSTALLATION
1.
!
Collect the following items
(2) Large control horn with back plate
(4) 2-56 x 3/4" screw
(2) 1/16 x 7" threaded wire
(2) Snap link
(1) Nylon snap nut (molded 6-up)